Owner manual

13
Figure 10
Install pinion shas, block, pins and springs
Assembly of the LOCK-RIGHT Parts into the
Dierenal Case
Summary of steps in this secon:
a) Install ring gear side coupler and washer
b) Install ring gear side driver and spacer
c) Install pinion sha block and shas
d) Install springs and pins
e) Install pins and springs another driver
f) Install other driver and spacer
g) Install other side gear and thrust washer
h) Install case cap
1. Place a thrust washer into the boom of the case,
smoothest side up, and place the gear that formerly was in the
top of the case into the boom (Figure 8).
2. Place a driver onto the side gear in the case, with
the teeth meashed, and place one of the spacers in the middle
(Figure 9).