Manual

5
LOCK-RIGHT Installaons Covered
in This Manual
Removable third member axles. Typical of these are
Toyota® 4-cylinder engine vehicles, both front and rear; similar
appicaons in Nissan®, Isuzu®; certain domesc applicaons, etc.
Preliminary Steps
The following steps are only a general guide to prelimi-
nary operaons used for preparing your vehicle for LOCK-RIGHT
installaon. For detailed informaon, refer to your shop manual.
In general, the preliminary steps include:
a) Blocking the vehicle, pung transmission in neutral;
b) Loosening the wheel lug nuts (the removal may be
oponal; see shop manual);
c) Jacking up the axle; securely resng it on jack stands;
d) Removing the res (some axles);
e) Disconnecng the brake lines and emergency brake
cables (some axles);
f) Pulling out one or both axles a few inches.
Removal and Disassembly
Summary of steps in this secon:
a) Securely block and jack up vehicle
b) Pull out axle shas by about six inches
c) Remove third member from vehicle
d) Observe ring gear backlash
e) Mark bearing caps and adjusters
f) Remove dierenal case from carrier
g) Mark bearing races
h) Remove ring gear
i) Remove internal parts
j) Install LOCK-RIGHT