Manual

Figure 6

Install thrust washer on each coupler

Assembly of the LOCK-RIGHT Parts into the

Dierenal Case

Summary of steps in this secon:

a) Install Ring gear side coupler and washer

b) Install other coupler and washer

c) Install le driver and spacer assembly

d) Install other driver

1. Install a coupler and washer assembly in the ring

gear end of the dierenal case. See Figure 7. Note that the

couplers in some models may have ats for clearance.

2. Place the second coupler and washer assembly into

the other end of the dierenal case (Figure 7).

3. Important! Be sure to have the spacers correctly ori-

ented and placed in the drivers before doing the following steps!

4. Pick up a driver-and-spacer assembly. Orient its

teeth toward the ring gear ange and hold it so that the ats (if

present) will clear the sides of the case. Place it on the teeth of