User Manual

23
piece of small wire (a paper clip works well) under the spring
and pop the boom out. Push the pin out of the pin hole and
into the window hole. Repeat for the other three springs and
pins.
3. Move the right driver to the le, touching the le
driver.
4. Move the right spacer to the le, into the center of
the le driver. (Use the U-shaped wire tool.)
5. Rotate the le re and both drivers unl the C-Clip
installaon recess in the teeth of the right driver is poinng
down.
6. Tap the right re inward to release the C-Clip so
that it falls down, through the recess.
7. Rotate the le re to rotate both drivers and allow
the C-Clip to drop out of the case.
8. Pull the right re out about one inch.
9. Push the spacers into the centers of the drivers.
10. Remove the driver and spacer opposite the ring
gear ange rst and then remove the second driver.
11. Remove the le C-Clip.
12. Remove the couplers.
Secon 8: Technical Assistance
Secon 9: Warranty Informaon
If you have general quesons, please contact your local
dealer for assistance. If your quesons are of a more technical
nature, you may call RICHMOND GEAR TechLine: 1-xxx-xxx-xxxx
for further informaon.
The Warranty is contained in the Vehicle Owner’s Man-
ual that is supplied with your new LOCK-RIGHT. Consult this
manual for complete warranty informaon.