User Manual

14
h) Rotate the right re 1/4-turn unl the
C-Clip ends are poinng downward, so that
it will not fall o.
i) Rotate the le re to posion both drivers
so that the large semi-circular recess in the
right driver is facing out.
j) Push the right driver to the right and into
the grease in the coupler teeth.
k) Through the semi-circular recess, push the
right spacer to the right, over the C-Clip and
axle sha end.
Secon 3: Dierenal Case Assembly
Compleon (All Models)
NOTE: These steps are for the dierenal case that has
been removed from the vehicle and is on the bench, as well as
for those remaining in the vehicle.
Summary of steps in this secon:
a) Rotate drivers; align holes
b) Push shear pin into other driver
c) Install spring assembly
d) Repeat for other pins and springs
e) Push spacers outward
f) Install pinion sha and retaining pin
1. Rotate the right driver unl one of its long window
holes (containing a pin) faces out, and rotate the other driver
unl one of its empty pin holes lines up with the rst window
hole.
2. Push the pin out of the window hole and into the
pin hole in the opposite driver with a small pointed tool (Figure
6).
3. Place one end of a spring assembly (small spring in-
side the large one) into the window hole, behind the pin (Figure
7). Compress it with a small screwdriver and pop the boom
into the window hole (Figure 8).