User Manual

13
Figure 5
C-Clip axles—install C-Clip and right driver
b) Place the other driver assembly in the
dierenal case. Push it to the le, touching
the other driver (Figure 5).
c) Using the U-shaped wire between the
driver and coupler teeth, push its spacer
leward into the center of the le driver to
help hold it temporarily in place.
d) Rotate both drivers with the le re unl
the C-Clip installaon recess in the right
driver teeth is poinng out.
e) Tap the right re inward, unl the boom
of the groove in the end of the axle sha is
even with the surface of the coupler. Keep
the coupler seated in the case.
f) Slide the other C-Clip through the recess in
the teeth and into the groove in the axle
sha end (Figure 5).
g) Pull the right re out sharply to seat the
C-Clip.