PowerJack Installation Manual
Technical Information(STA) Dimensions Frame Side&Door Side: Btype:195x25x50 mm Use with Fail Secure/PTO Locks Only Electrical rating Input 600mA, 24V DC, powered by Class 2 or Class 3 power limited source. The length of connect cable is not great than 30m. Output 500mAƒ12V DC ƒ 250mAƒ24V DC Max door gap: Door side (Receive): I/O Atype:131x25x37 mm Frame Side (Side): 7.0mm; Horizontal < 2mm, vertical < 2mm with door gap 5.
PowerJack Dimensions Atype Btype 2
Installation Steps Step1: Survey installation site Requires depth of 47mm (1 7/8”) in both of frame and door side Step2: Location Apply the templates on the door side& frame side, make sure door side& frame side are aligned. Align the central line on template Step3: Installation in wood door or frame a. Drill a hole for faceplate of depth of 3mm*1/8”+ and diameter25mm*1”+ in the marked place by Electrodrill.
b. Drill a hole for PowerJack of depth of 7mm*1 7/8”+ and diameter 25mm*1”+ in the marked place. c.
d. Drill a wiring channel for connection to the device to be powered e.
Step4 Installation in metal door or frame a. Drill M3 countersunk screws hole according to template b.
c. Put the PowerJack inside the pocket to see if it fits the space d.
Step5. Voltage Selection and wiring a. Select output voltage of 12V or 24V by adjusting indicated switch (Voltage adjustment only required to adjust door side) b. Supply output 24 VDC to frame unit. Connect red wire to positive(+) and black wire to negative(-) c. Connect door side unit with the electronic device via wiring channel, connect orange wire to positive(+) and black wire to negative(-).
d. Sensor Wiring Diagram +[RED] Power Supply 24V SWITCH #1 [BLUE] SWITCH #1 [GRAY] - [BLACK] SWITCH #2 [YELLOW] SWITCH #2 [WHITE] Momentry Open (3 seconds) [GREEN] Common [YELLOW] Hold to Open(max.
Step6 Mount PowerJack a. Wood: use wood self-tapping screws b.
FCC WARNING STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any change or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
