Product Manual

ASSEMBLY INSTRUCTIONS (CONTINUED) POWERTEK
BEFORE EACH USE DO THE FOLLOWING:
1. Make sure all bolts, fittings, and hoses are tight. If fittings are not tight, log splitter
will not function properly.
2. Make sure you have read the all safety and start up procedures in the Operation and
Maintenance Manual.
3. Make sure that Dextron III or equivalent hydraulic oil is used in the hydraulic system
before starting the engine.
4. Check for oil leaks on initial start-up. Repair any hydraulic lines, as necessary.
5. Double check oil levels in engine and hydraulic system before splitting your wood.
6. While towing, obey all local and state laws.
7. If towing over the road, make sure that the fuel shut off is in the off position on the engine
gas tank.
SERVICE TIPS
1. To clean the hydraulic screens (drain tank before removing screen) remove the screen from
the reservoir and clean in a petroleum-based solvent. Clean inside of tank, air-dry screen
and replace in reservoir. Tighten.
2. To drain hydraulic tank, remove 1/2" x 15” hose from valve and drain the contents into a
container. To drain cylinder, remove the 1/2" x 54" and 1/2" x 42" hose from the valve.
Point hoses into a container and manually pull cylinder forward until all fluid is expelled.
Re-attach hoses and tighten. Refill with fresh fluid. See page 11 of this Operation &
Maintenance Manual for frequency of fluid change and type of fluid to be used. Dispose of
all used fluids according to local, state and Federal environmental regulations.
3