Product Manual
Table Of Contents
- 16-20 COVER
- 16-20 PAGE 1
- TABLE OF CONTENTS
- WARNINGS SAFETY...........…...............................................……………………………….2-3
- GRINDING STUMPS..........................................................…………………...………………..8
- EXPLODED VIEW 16/20 P & 16/24 P....…....................................………………….…..…..17
- PARTS LIST 16/20 P & 16/24 P.................................................………………….………......18
- TABLE OF CONTENTS
- 16-20 PAGE 2
- 16-20 PAGE 3
- 16-20 PAGE 4
- 16-20 PAGE 5
- 16-20 PAGE 6
- 16-20 PAGE 7
- 16-20 PAGE 8
- 16-20 PAGE 9
- 16-20 PAGE 10
- 16-20 PAGE 11
- 16-20 PAGE 12
- 16-20 PAGE 13
- 16-20 PAGE 14
- MAINTENANCE POWERTEK
- HYDRAULIC OIL
- MAINTENANCE SCHEDULE
- Daily
- Weekly
- Monthly
- Check engine oil
- 16-20 PAGE 15
- 16-20 PAGE 16
- 16-20 PAGE 17
- 16-20 PAGE 18
- 16-20 PAGE 19
- 16-20 PAGE 20
- 16-20 PAGE 21
OPERATION POWERTEK
BY PASS CONTROL (SP)
The hydrostatic also has a 'by-pass" control which enables the operator to manually move the
machine when desired. This control is located at the rear of the main frame-lower left-hand side
and is clearly identified. To put the grinder in a "free-wheeling mode" rotate the bypass handle
up until it locks in place. To return it to powered travel, lower the bypass handle to original
position. See Fig. 5.
! CAUTION
DO NOT start or run the engine with the “by-pass” lever in the “up” or the “free-
wheeling” position! DAMAGE will occur to the hydrostatic transmission. Use the “up”
position ONLY when you wish to move the unit manually without the engine running.
(Fig. 5)
STOPPING (SP)
1. Turn the clutch switch off.
2. Gradually reduce the throttle down idle.
3. Turn the ignition switch off.
4. Release presence control bar remember the stump grinder will not restart until clutch switch is
turned off. Releasing the presence control bar will stop the stumper at anytime.
Important Note: Make sure to allow the cutter wheel to stop spinning before lowering the
stump grinder nose to the ground.
10