Product Manual
Table Of Contents
- 16-20 COVER
- 16-20 PAGE 1
- TABLE OF CONTENTS
- WARNINGS SAFETY...........…...............................................……………………………….2-3
- GRINDING STUMPS..........................................................…………………...………………..8
- EXPLODED VIEW 16/20 P & 16/24 P....…....................................………………….…..…..17
- PARTS LIST 16/20 P & 16/24 P.................................................………………….………......18
- TABLE OF CONTENTS
- 16-20 PAGE 2
- 16-20 PAGE 3
- 16-20 PAGE 4
- 16-20 PAGE 5
- 16-20 PAGE 6
- 16-20 PAGE 7
- 16-20 PAGE 8
- 16-20 PAGE 9
- 16-20 PAGE 10
- 16-20 PAGE 11
- 16-20 PAGE 12
- 16-20 PAGE 13
- 16-20 PAGE 14
- MAINTENANCE POWERTEK
- HYDRAULIC OIL
- MAINTENANCE SCHEDULE
- Daily
- Weekly
- Monthly
- Check engine oil
- 16-20 PAGE 15
- 16-20 PAGE 16
- 16-20 PAGE 17
- 16-20 PAGE 18
- 16-20 PAGE 19
- 16-20 PAGE 20
- 16-20 PAGE 21
MAINTENANCE POWERTEK
SHARPENING CUTTERS
The cutters should be sharpened frequently for higher performance and a longer life. It is also
easier to grind them if they are ground often.
*You will need a carbide-grinding wheel (green wheel) to sharpen them. Use a coarse grinding
wheel to grind the steel shank. Be sure to maintain the back grind of 15 degrees (approximately).
The cutters must be replaced when the tooth has been sharpened so that 1/4" (approximately) of
the carbide is left.
(Fig. 8)
TOOTH SELECTION
WHEN ORDERING TEETH USE THIS GUIDE TO ORDER SINGLE TEETH.
16265 (L.H.) 16263 (ST.) 16264 (R.H.)
12