Operation Manual

SECTION 3
“GENERATOR END”
SAFETY PRECAUTIONS _________________________________________________ 1-2
INSTALLATION REQUIREMENTS_________________________________________ 3
GENERATOR ASSEMBLY INFORMATION__________________________________ 4-5
ENGINE and GENERATOR DIAGRAM_____________________________________ 6
SECTION A: GENERATOR
MARATHON MAGNAPLUS GENERATOR MANUAL __________________________ 1-19
Installation
Operation
Maintenance
SECTION B: VOLTAGE REGULATORS and ENGINE CONTROLLERS
MARATHON SE350 VOLTAGE REGULATOR INSTRUCTION MANUAL _______________ 1-4
BASLER AVC64-4 ANALOG VOLTAGE CONTROLLER ______________________________ 5-7
PT-ECU-64 ENGINE CONTROL MODULE __________________________________________ 8
APEC 3100 ELECTRONIC ENGINE SPEED GOVERNING SYSTEM _____________________ 9
GAC ESD2110 SERIES SPEED CONTROL MODULE _________________________________ 10
SECTION C: WIRING SCHEMATICS
REDCO PANEL ASSEMBLY _____________________________________________________ 1 of 9
SMIP BOX WIRING / 3 PHASE____________________________________________________
1 of 1
12 LEAD ZIG ZAG ______________________________________________________________
1 of 1
3-PHASE 12 LEAD HI DELTA ____________________________________________________
1 of 1
3-PHASE 12 LEAD HI WYE ______________________________________________________
1 of 1
3-PHASE 12 LEAD LOW WYE ____________________________________________________
1 of 1
12-VOLT DC ENGINE CONTROL CIRCUIT PT-ECU-64 _______________________________
1 of 1
12-VOLT DC ENGINE CONTROL CIRCUIT GAC ESD 2110 ___________________________
1 of 1
12-VOLT DC ENGINE CONTROL CIRCUIT SERIES 200 BOX _________________________ 1 of 1
120 VOLT, SINGLE PHASE, 4 WIRE CONNECTION “M” SERIES EXCITER TYPE________ 1
120/240 VOLT, SINGLE PHASE, 4 WIRE CONNECTION “M” SERIES EXCITER TYPE_____ 2
220 VOLT, SINGLE PHASE, 4 WIRE EUROPEAN CONNECTION “M” SERIES EXCITER TYPE 3
RESISTANCE CHART 30 – 35 – 40KW “M” SERIES EXCITER TYPE____________________ 4
SECTION D: GENERATOR END TROUBLESHOOTING GUIDES
ZERO OR LOW VOLTAGE _______________________________________________________ 1
VOLTAGE TEST / 12 VOLT BATTERY TEST _______________________________________ 2
OVERLOAD CONDITION ________________________________________________________ 3
OPTIONS:
DYNA-GEN OPTIMAL SERIES AUTOMATIC TRANSFER SWITCH _________ Manual Supplied with Switch
DYNA-GEN TSC3 TIMER MODULE ____________________________________ Manual Supplied with Timer
PHILLIPS & TEMRO INDUSTRIES ENGINE PRE-HEATER ____________________________
1-3
MASTER CONTROL SYSTEMS MBC-19 BATTERY CHARGER ________________________ 1-4
RACOR 200R SPIN-ON SERIES FUEL FILTER / WATER SEPERATOR __________________ 1-4