Quick Start Guide

Manual: PTG Controller Quick Start Guide
6
2.2 Using the Menu System
Task
Description
Entering Menu
When in the OFF mode, press the enter button to bring up the
menu.
Navigating Menu
Once in the menu, use the up and down arrows to navigate.
Pressing enter will move you into that menu.
Scroll Parameters
When in Auto or Running mode, pressing the up and down
arrows will scroll through the parameters pages.
Lock Screen
When in Auto or Running mode, you can lock the screen onto a
certain parameter page by pressing enter. You can unlock the
screen by pressing enter again.
Events History
Once in the menu, select Events History to view the most recent
controller event. Use the up and down arrows to navigate to other
events. The controller can store up to 150 events. If more than
150 events occur, the oldest event is deleted to make room for
the next event.
2.3 Modes, Starting and Stopping Methods
The following table describes the different operating modes of the controller:
Modes
Mode / State
Description
OFF
When in the OFF mode, the engine cannot be remotely started.
Auto
When in the Auto mode, the engine waits to receive a start
command.
Running
When engine is Running, the controller monitors engine
parameters and waits to receive a stop command.
Failure
When a failure occurs, the controller shuts down the engine and
displays reason for failure. The unit must be reset using the front
panel OFF button with the exception of Modbus.
Menu
When in the menu you can change settings and view the events
history.
The following table describes the different methods in which a controller can start. The
controller must be in the AUTO mode in order to start for all methods with the exception
of Manual Run.