User's Manual

Note: Wall Mounting is available only on Strip and Block type Surge Protector.

1. There are mounting holes on the back of the Surge Protector for wall or base

board mounting.

2. Install screws (not included) on wall or baseboard surface (leaving at least 1/4

inch of the screw exposed).

3. Place and secure the Surge Protector on mounted screws.

Mounting the USB Transmitter

1. Select a spot within the wireless range to mount the supplied USB wall bracket.

2. The ideal locations for USB wall mount are entrance of a room or location

where USB wall mount can be easily seem and accessed.

3. Use adhesive tape or supplied screws to securely attach the supplied wall

bracket to a wall.

CONNECTING INSTRUCTION

Before you start, take a few minutes to understand the conditions for the USB

Transmitter to work correctly.

Few devices will always have power in its USB port regardless the on/off status of

the devices. This is due to convenience reason that the user can still use the USB

port with other handheld devices. In this case, the devices usually have higher

stand-by power since the USB port always draws power from the devices.

Since the USB Transmitter detects the power on/off status in device USB port to

correctly control the ENERGY SAVER outlets on the Surge Protector, the USB

Transmitter will not work with device that always has power in its USB port when

it is completely turned off.

The USB Transmitter is a great tool to check if your device USB port continues to

draw power while it’s turned off.

While your device is off, connect the USB Transmitter to one of its USB port. If the

red LED light illuminates, this indicates there is still power in the USB port when

the device is off. Locate and use another USB port that does not always have

power in it for the USB Transmitter to correctly function.

Step 1

Connect electronic devices to the “ENERGY SAVER” outlets

“ENERGY SAVER OUTLETS”

These outlets are for devices which do not need to be on all the time and can be

completely turned off when not in use. These outlets are automatically switched

On and Off by the wireless USB Transmitter for energy conservation purpose

The ideal electronic devices for “ENERGY SAVER OUTLETS” are listed below

Step 2

Connect electronic devices to the “ALWAYS ON” outlets

IN HOME ENTERTAINMENT

DVD Amplifier

Game Console Subwoofer

IN HOME OFFICE

Monitor Speakers

scanner Printer

USB Smart Surge Manual All Versions V1.0