User's Manual

FEATURES

USB TRANSMITTER

■ Learning and Grouping capability

- One USB Transmitter can group with multi Surge Protectors by learning

capability.

- Pre-learn the USB Transmitter with Surge Protectors at home and in the

office. Enjoy the convenience of carrying just one pocket size USB

Transmitter to control Surge Protectors at both locations.

■ Stand-alone wireless remote function

- The USB Transmitter can be used as a stand-alone wireless remote to turn

On or Off the “ENERGY SAVER outlets” on the Surge Protector

SURGE PROTECTOR

■ Controlled by the USB Transmitter, the ENERGY SAVER outlets on the Surge

Protector automatically switch On or Off to eliminate unnecessary energy

waste.

■ Advanced Surge Protection protects your electronic equipments from surges

and voltage spikes.

■ EMI/RFI Noise Filtration eliminates the interference and improves the

performance of your electronic equipments.

INSTALLATION

USB TRANSMITTER WIRELESS RANGE

In open space, the USB Transmitter has a wireless range up to 25 feet* to control

the Surge Protector.

* Actual range may vary depending on environment condition, interference and

building materials.

REPLACING USB TRANSMITTER BATTERY

One 3V CR1632 Lithium battery is included and pre-installed in the USB

Transmitter.

When the button on the Transmitter is pressed, a red LED will illuminate to

indicate that the Transmitter is working and battery is OK.

If the LED light goes very dim or does not illuminate, it is time to replace the

battery*.

＊The only battery can be used in the USB Transmitter is 3V CR1632 flat type Lithium battery.

Battery Replacement

1. There is a notch on both sides of the USB Transmitter.

2. Use a coin, as a lever to twist open the covers.

3. Slide the battery out of holder, and replace the new battery (+ Positive upward)

by sliding it in the battery holder

WALL MOUNTING

Mounting the Surge Protector

USB Smart Surge Manual All Versions V1.0