Use and Care Manual

6
ASSEMBLY
TO CONVERT
1.
2.
3. Follow the 240V wiring diagram on the inside of the switch
box cover. NOTE: The 240V wiring diagram is also in
847-780-6120 for
4. After rewiring make sure all wire nuts are tight and use
Figure 7
5. Replace the plug on the existing power cord with a NEMA
6-15 plug. The plug must be plugged into matching outlet
that is properly installed and grounded in accordance with all
local codes and ordinances.
6.
7.
OPERATION
6
6
OPERATION
BASIC OPERATIONS
ON/OFF Switch
The keyed switch is intended to prevent unauthorized use of the
1. To turn the dust collector ON insert the yellow key into the
2.
3. To turn the dust collector OFF push the switch to the
4. Remove the yellow switch key, when the dust collector has
WARNING
Remove the switch key whenever the dust collector is not in
WARNING
ALWAYS lock the switch OFF when the dust collector is not in
use. Remove the key and keep it in a safe place. In the event
of power failure, blown fuse, or tripped circuit breaker, turn the
switch OFF and remove the key, preventing accidental startup
Figure 8
Operation
1.
2. Connect one end of a dust collector hose to the dust
collector inlet and one end to the machine outlet. Secure
3. Turn the dust collector ON. (Refer to On/Off Switch paragraph
in this section of the manual).
Figure 9
On/Off Switch
Yellow
Switch Key
Dust Collector Hose
Dust Collector Inlet