Use and Care Manual

ASSEMBLY
3
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether all parts
and accessories are included. If anything is missing or broken,
contact your retailer or call 847-780-6120.
NOTE: Carefully remove all contents from shipping carton. The
shipping carton contains:
ITEM DESCRIPTION QTY
A Motor with Paddle Switch and Dust Box 1
B Dust Collection Bag 1
C Base 1
D Casters 4
E Bag Clamp 5" 1
F Adhesive Foam Strip 1
G Carriage Bolts M8 8
H Acorn Nuts 5-16"-18 4
I Flat Washers 5/16" 4
J Wrench (10-12 mm) 1
K Motor Plate 1
Figure 1
INSTALLATION
Refer to Figures 2–4
Tools required for assembly:
•
CAUTION
•
• Call the Customer service line to obtain
WARNING
Do not operate dust collector until completely assembled.
Do not operate this tool until you have completely read and
NOTE: After unit is assembled dispose of all packaging material
1. Place the base plate upside down and attach the casters with
Figure 2
2. Align holes in motor plate with holes in motor housing (Figure 3)
secure braket in palce with four carriage bolts and ange nuts
(supplied). Please make sure the square-neck of the carriage
bolts are properly mounted into the square holes of motor plate.
Figure 3
ASSEMBLY
3
L Flange Nuts M8 8
Owner's Manual (not shown)
Align holes in motor plate with holes in base plate, secure in
palce with four carriage bolts and ange nuts (supplied).
A
B
E
F
J
H
I
C
D
K
G
L
Casters
Motor Plate
Base
Flange Nut
Carriage Bolt
Flange Nut
Carriage Bolt
Motor Plate
Motor with Paddle Switch
and Dust Box
Refer to Figure 2