Use and Care Manual
GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use of
any other parts may create a hazard or cause product damage.
To ensure safety and reliability, all repairs should be performed
by a qualified service technician.
WARNING
Keep the trim router table dry, clean, and free from oil and
grease. Always use a clean cloth when cleaning. Never use
brake fluids, gasoline, petroleum based products or any
strong solvent to clean the trim router table. Chemicals can
damage, weaken or destroy plastic which may result in serious
personal injury.
MAINTENANCE
4
MAINTENANCE
4
INSTALLING ROUTER IN TABLE
1. Loosen the fence locking knobs and slide the fence back on
the tabletop to access the opening in the tabletop.
2. From the top of the table, lower the router with trim router
base into the opening, align the three stopped holes on the
underside of the router base with the three leveling screws.
Figure 8
Stopped holes in trim
router base aligned
with leveling screw
Stopped holes in trim
router base aligned
with leveling screw
Use a straight edge to verify the trim router base is flush with the
tabletop. If it is not flush, adjust the leveling screws until the
router base plate is flush with the tabletop. Make sure the
leveling screws are seated in the three stopped holes on the
underside of the router base to prevent the base from shifting
during use.
10
9
8
7
6
5
4
3
2
10
321 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
25 0
Figure 9
Hex
Wrench
included
4
ASSEMBLY
Trim Router Base
• Carnauba wax may be applied to the universal router plate to
reduce scratching and make it slide easier. If scratching does
occur, carefully polish with plastic polish until the scratches
are removed.
3. Attach the bit guard to the front of the fence using the bit
guard knobs.
NOTE: To adjust the bit guard, loosen the knobs, slide
the bit guard up and down to desired application and
tighten knobs.
4. Adjust the fence to the desired application and tighten the
locking knobs.
5. Attach the dust extraction hose to the dust port.
Figure 10
Bit Guard
Bit Guard
Knobs
WARNING
The trim router table MUST be clamped in place or attached
directly to a solid mounting surface BEFORE operating the
router. Figure 5 shows the trim router table with cleat clamped
into place.