Use and Care Manual

ASSEMBLY

INSTALLING ROUTER IN TABLE

1. Loosen the fence locking knobs and slide the fence back on

the tabletop to access the opening in the tabletop.

2. From the top of the table, lower the router with trim router

base into the opening, align the three stopped holes on the

underside of the router base with the three leveling screws.

Figure 8

3. Use a straight edge to verify the trim router base is ush with

the tabletop. If it is not ush, adjust the leveling screws until

the router base plate is ush with the tabletop. Make sure

the leveling screws are seated in the three stopped holes on

the underside of the router base to prevent the base from

shifting during use.

Figure 9

4. Attach the bit guard to the front of the fence using the bit

guard knobs.

NOTE: To adjust the bit guard, loosen the knobs, slide the bit

guard up and down to desired application and tighten knobs. To

temporarily remove the bit guard, slightly loosen the bit guard

knobs and slide the guard up and over theknobs.

5. Adjust the fence to the desired application and tighten the

locking knobs.

6. Attach the dust extraction hose to the dust port.

Figure 10

WARNING

The trim router table MUST be clamped in place or attached

directly to a solid mounting surface BEFORE operating the

router. Figure 5 shows the trim router table with cleat clamped

into place.

WARNING

When servicing, use only identical replacement parts. Use of

any other parts may create a hazard or cause product damage.

To ensure safety and reliability, all repairs should be preformed

by a qualied service technician.

WARNING

Keep the Trim Router Table dry, clean, and free from oil and

grease. Always use a clean cloth when cleaning. Never use brake

uids, gasoline, petroleum-based products or any strong solvent

to clean the Trim Router Table . Chemicals can damage, weaken

or destroy plastic which may result in serious personal injury.

Trim Router Base:

• Carnauba Wax may be applied to the universal router plate

to reduce scratching and make it slide easier. If scratching

does occur, carefully polish with plastic polish until

scratches are removed.

GENERAL MAINTENANCE