Use and Care Manual

ASSEMBLY
3
Figure 4
5. Clamp or Attach the Table to Stationary Work Surface:
a. If the cleat was assembled earlier, clamp it to the edge
of a bench, table, piece ofplywood or other stationary
work surface.
b. The table may be attached directly to a stationary
work surface. Drive #8 screws through the three cleat
mounting holes and into the stationary worksurface.
IMPORTANT: The screw length will be determined by the work
surface thickness. The general rule is for the screw to enter at
least half the thickness of the bottommaterial/work surface.
Figure 5
6. Install the three leveling screws from the bottom into the
holes on the lip of the opening in the table.
NOTE:These screws are used to make the router base flush
with the face of the tabletop. These screws will also register the
three stopped holes in the underside of the trim router base to
keep it from shifting during use.
Figure 6
ASSEMBLE THE TRIM ROUTER BASE
WARNING
To reduce the risk of injury, turn router off and disconnect it from
power source before installing and removing accessories. An
accidental start-up can cause injury.
NOTE: This clear router plate provides better visibility and
when used with a PORTER-CABLE style guide bushing (sold
separately) it allows a bit to follow the path intended by a
template or jig.
NOTE: The trim router base can be left on the router, allowing
it to be taken from table routing to hand held routing without
switching baseplates.
1. Remove the existing router plate and all related hardware
from the router.
2. On the chart nd the model and the corresponding letter for
your router.
3. Find the corresponding letters for your router in Figure7.
NOTE: Some routers have more than oneoption.
4. Place the universal router plate onto the router and line up
the rst letter with the appropriate hole and then rotate the
plate until all holes for the pattern line up. Install and tighten
the machine screws.
Figure 7
KNOWN COMPATIBLE ROUTERS
DEWALT* DWP611PK B Fixed Base
Makita* RT0701CX7 D
Fixed Base
(196613-4)
Bosch*
GKF125CEN E
Fixed Base
(PR001, PR101)
PR10E/PR20EVS F
Fixed Base
(PR001, PR101)
Ryobi* P601 G
PORTER-CABLE* PCE6435 H
* DEWALT and PORTER-CABLE are trademarks of The Stanley Black & Decker
Corporation—Bosch is a trademark of the Robert Bosch Tool Corporation—Makita
is a trademark of Makita Corporation—Ryobi is a trademark of Ryobi Limited and
is used by Techtronic Industries Company LTD.