Use and Care Manual

2
PARTS AND CONTENT
2
ASSEMBLY
PARTS AND CONTENT
2
ASSEMBLY
2
ASSEMBLE FENCE, DUST PORT ANDTABLE
Refer to Figures 2–6
1. From the underside of the fence, insert the two T-Bolts up
and through the holes on each end the fence. Place a 5/16"
washer on each T-Bolt and then thread on the fence lock
knobs. Do not tighten the knobs.
2. Attach the POWERTEC Dust Port to the back of the fence
using the pan head screws and 1/4" washers.
Figure 2
3. Optional mounting: The trim router table may be attached
to a longer board or cleat for clamping to a stationary work
surface. If using this method, add the cleat now. There are
pre-drilled cleat mounting holes at the rear of the trim router
table. Drive #8 screws through the three cleat mounting
holes and into the cleat.
NOTE: The screw length should be the thickness of the trim
router table plus the cleat.
Figure 3
4. Install the fence to the table. Make sure the T-Bolt heads
extend down far enough to t into the fence adjustment slots
in the table. Insert the T-Bolt heads into the round access
holes in the tabletop, engage the heads in the stepped slots
on the underside of the table and slide the fence toward
theback.
NOTE: To adjust the fence, loosen the knobs, slide the fence to
the desired application and tighten knobs.
WARNING
The trim router table MUST be clamped or attached directly to a
stationary work surface BEFORE operating the router. Figure5
shows the trim router table with cleat clamped to a stationary
work surface.
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether all
parts and accessories are included.
ITEM DESCRIPTION QTY
A Router table top 1
B Bit guard 1
C Bit guard knobs 2
D
Universal trim router base
(Powertec 71381)
1
E
Router dust port
1
F
Router table fence
1
G
Fence lock knobs
2
H
T-Bolts 5/16"-18 x 4"
2
I
Washers 5/16"
2
J M4 x 10mm Pan Head Screws 2
K Washers 1/4" 2
L Hex wrench 3 mm 1
M Leveling screws 1" (hex head) 3
Figure 1
WARNING
Do not use the trim router table until it is completely assembled and
you have read and understood this entire operating manual and the
operating manual of the tool being used with this trim router table.