User Manual

SSYYSSTTEEMM IINNSSTTAALLLLAATTIIOONN
8
Figure 3: Mounting of computer shoe
33.. AAttttaacchh CCoommppuutteerr MMoouunntt ttoo HHaannddlleebbaarr
The computer mounts to the handlebar in a similar fashion. Position the foam mounting tape
beneath the mount and secure with cable ties to handlebar. The head of the cable tie fits flush
into a recessed cavity on the mount.
44.. PPllaaccee CCoommppuutteerr
Place the computer into the mounting shoe on the handlebar. Line up the slots on the base of the
computer with the bracket. Slide completely into computer mount.
(see figure 4)
55.. HHeeaarrtt RRaattee MMoonniittoorr SSttrraapp
Position the heart rate monitor strap on your torso as pictured in figure 6.
The strap should rest just beneath the pectoral muscles of the chest. Make
sure the electrodes on the strap are slightly moist where it contacts the
skin for best results. The heart rate strap must be worn to enable the heart
rate functionality of the PowerTap.
(see figure 5) The chest strap is not
coded.
66.. VVeerriiffyy IInnssttaallllaattiioonn
Check all the components to make sure they are securely attached.
Spin the rear wheel and verify that the transmission icon on the computer
display is illuminated. This indicates that the hub is sending a valid signal
through the receiver to the cpu. (see figure 6). Adjust the receiver
if necessary.
Figure 4: Attaching of computer Figure 5: Placement of heart rate strap
Figure 6:Transmission icon in
upper left corner of display