Instructions / Assembly

995000531
2-8-18 (REV:02)
WARNING:
This quick reference guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand
operator’s manual before using this product. All page references refer to the operator’s manual.
Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 11).
1
2
When finished, push the start button to stop the motor. Light will turn off to indicate unit is off. (See page 11)
3
Push the start button to start the motor. Light will turn on to indicate unit is on. (See page 11).
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
Use the chart below to determine the correct nozzle for your job.
2
Install blue or black soap
nozzle (see page 12).
1
Pour pressure washer
detergent in soap tank
(see page 13).
3
Squeeze trigger and wait
approx. 5 seconds for
detergent (see page 13).
5 S
This pressure washer is not recommended for use with an extension cord. If using an extension cord, arrange a
drip loop to avoid the possibility of the tool plug getting wet (see pages 2 and 7).
PUMP
PROTECTOR
Install the wheels (see page 9).
Install the handle, nozzle storage bracket, and
trigger handle holder (see page 9).
1
2
3
Connect the high pressure hose to the trigger
handle (see page 9).
Connect the high pressure hose to the pump
(see page 9).
Connect your garden hose to the pressure washer
(see page 10).
4
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
PRESS START
BUTTON AGAIN
TO TURN OFF
DETERGENT
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Turbo
Nozzle 15º 25º 40º
Blue
Soap Nozzle
Concrete, Brick, Masonry
    
Siding, Gutters, House
   
Fencing, Deck, Patio
   
Lawn Equipment, Boat, RV
   
 Recommended Nozzle
 Use With Caution for Certain Applications
PS142012 QUICK REFERENCE GUIDE
USING DETERGENT
NOZZLE SELECTION GUIDE
BEFORE STORING THE UNIT
Always add Pump Protector to the unit after each use and before storing. This will significantly improve
pump life. (See page 14)
Pump Protector is available from your local retailer. For further assistance, call customer service at
1-877-617-3501.
To add, follow the instructions provided by the Pump Protector manufacturer.
1
Make the most of your purchase! Go to www.powerstroketools.com
and register your new tool online. For questions about operating or
maintaining your product, please call 1-877-617-3501.
FIRST TIME ASSEMBLY STARTING THE UNIT
Connect the spray wand to the trigger handle
(see page 9).
5
6
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length Wire Size (A.W.G.)
25 ft. (7.6 m) 12
50 ft. (15.2 m) Not Allowed
NOTE: A.W.G. = American Wire Gauge
PRESS START
BUTTON TO
TURN ON
There may be residual
water in the pump due to
performance testing.