User manual

17
INSTRUCTIONS OF USE
1. Pour the non-flammable and non-tox-
ic liquid in its interior (preferably water,
although it can be non-potable water).
2. Place the device over a flame. Al-
though a small flame from an alcohol or
kerosene burner is enough, it will
perform better if the flame comes from
a gas burner. In any case, make sure it
does not surpass the edges of the
recipient. First of all because it will
exhaust unnecessarily the materials of
the device, and in the second place
because any flame that exceeds the
NANO diameter will have no heating
effect on its base.
3. Wait around two minutes. For mobile
phones and rechargeable batteries, two
minutes will be enough for the NANO to
reach the desired voltage. In case of light-
ing up several LED bulbs, or charge a
minitablet, its maximum performance
will be obtained after five to ten minutes,
and it will maintain it if the same heat is
provided on its base and there is water
inside.
4. Connect to the desired device. The
experience will tell us what is the neces-
sary flame. For small phones, this is sur-
prisingly small (such as the smaller flame
from a gas burner or the equivalent to
eight candles). For maximum perfor-
mance it will be necessary the medium
flame from a portable gas burner.
5.
S
u
p
erv
i
s
e the level o
f
w
a
ter and nev
er
let it dry
when it is placed over a f
lame.
I
n
case you forget, it will be irreparably
damaged,
so
it
is necessary to not leave
i
t unattended.
MAINTENANCE
Do not keep in the neoprene cover when hot. Do not close
the top if it is still wet.