User manual

17
INSTRUCTIONS OF USE
1. Pour the non-flammable and non-tox-
ic liquid in its interior (preferably water,
although it can be non-potable water).
2. Place the device over a flame. Al-
though a small flame from an alcohol or
kerosene burner is enough, it will
perform better if the flame comes from
a gas burner. In any case, make sure it
does not surpass the edges of the
recipient. First of all because it will
exhaust unnecessarily the materials of
the device, and in the second place
because any flame that exceeds the
MICRO diameter will have no heating
effect on its base.
3. Wait around two minutes. For mobile
phones and rechargeable batteries, two
minutes will be
enough for the MICRO to
reach
the
desired
voltage.
In
case
of
light
-
ing
up several LED bulbs, or charge a
tablet, its maximum performance will be
obtained after five to ten minutes, and it
will maintain it if the same heat is provided
on its base and there is water inside.
4. Connect to the desired device. The
experience will tell us what is the neces-
sary flame. For small phones, this is sur-
prisingly small (such as the smaller flame
from a gas burner or the equivalent to
eight candles). For maximum perfor-
mance it will be necessary the medium
flame from a portable gas burner.
5.
S
u
p
erv
i
s
e the level o
f
w
a
ter and nev
er
let it dry
when it is placed over a f
lame.
I
n
case you forget, it will be irreparably
damaged,
so
it
is necessary to not leave
i
t unattended.
MAINTENANCE
Do not keep in the neoprene cover when hot. Do not close
the top if it is still wet.