Use and Care Manual

FIG 3
D2
E2
E
E3
E1
B
B
F
A
C1
C2
D1
FIG 4
E3
E2
E1
FIG 2
1
G4
9
G2
2
G1
G3
H
7
4
English
ASSEMBLY INSTRUCTION
ATTACHING WORK LIGHT
HEADS TO STAND (FIG 2)
1.Placethestand(7)onaatsurface.
2.Rotatethecarryinghandle(1)straightup.Tighten
the handle locking knob (G3) to secure it in place.
3.Installoneworklighthead(2)onthestand(7)by
sliding and positioning the U-shape bracket (9)
undertheboltcap(G2)asshowninFIG2.Tighten
thelockingknob(G1)tosecuretheworklighthead
in place. Repeat the procedure on the second work
light head.
4.Hangthepowercablesplitter(H)onthehook(G4).
ADJUSTING THE TRIPOD (FIG 3)
1.Loosenthetripodlockingknob(F).
2.Pushdownthelegconnector(A)untilthelegs(B)
are fully extended and firmly tighten the locking
knob (F).
3. Adjust the height of the tripod by loosening the twist
collars(C1&C2)andraisingthecenterpoles(D1&
D2)oftripod.Firmlytightenthetwistcollarswhen
the tripod reaches desired height.
NOTE:Themaximumheightofthistripodis60".
ATTACHING THE WORK LIGHT
ASSEMBLY TO THE TRIPOD
(FIG 4)
1.Placetheworklightassemblyontopofthetripod.
2.Use the bracket locking system (E1, E2 and E3)
to secure the work light assembly to the tripod as
showninFIG4.
NOTE:Makesurethetwolockingbrackets(E1)are
over the raised metal plate in the middle of the stand.