Use and Care Manual

FIG 3
D2
E2
E
E3
E1
B
B
F
A
C1
C2
D1
FIG 4
E3
E2
E1
FIG 2
7
1
H
G4
2
G3
G1
G1
4
English
ASSEMBLY INSTRUCTION
ATTACHING WORK LIGHT
HEADS TO STAND (FIG 2)
1.Placethestand(7)onaatsurface.
2.Rotatethe carryinghandle(1)straight up.Tighten
thehandlelockingknob(G3)tosecureitinplace.
3.Usethelockingknobs(G1),atwashersandspring
washers to secure both work light heads to the sides
ofthestandasshowninFIG2.
4.Hangthepowercablesplitter(H)onthehook(G4).
ADJUSTING THE TRIPOD (FIG 3)
1.Loosenthetripodlockingknob(F).
2.Pushdownthelegconnector(A)untilthelegs(B)
are fully extended and firmly tighten the locking
knob (F).
3.Adjusttheheightofthetripodbylooseningthetwist
collars(C1&C2)andraisingthecenterpoles(D1&
D2)oftripod.Firmlytightenthetwistcollarswhen
the tripod reaches desired height.
NOTE:Themaximumheightofthistripodis48".
ATTACHING THE WORK LIGHT
ASSEMBLY TO THE TRIPOD
(FIG 4)
1.Placetheworklightassemblyontopofthetripod.
2.Use the bracket locking system (E1, E2 and E3)
to secure the work light assembly to the tripod as
showninFIG4.
NOTE:Makesurethetwolockingbrackets(E1)are
over the raised metal plate in the middle of the stand.