Use and Care Manual

2
FIG 8
FIG 7
FIG 6
FIG 9
FIG 5
B
A
6
English
ON-BOARD SWITCH
Yourlighthasaredon-boardswitch(5-FIG1).SeeFigure1foritslocation.ThisswitchturnsthelightOnandOffand
controls the light mode. The light mode cycles in the following sequence with each press on the switch:
High - Medium - Low - Night Light - OFF
Theswitchhasadelayed"OFF"function.Ifalightmodestaysonformorethan15seconds,thenextpressofthe
switch will turn off the light.
REMOTE CONTROL (FIG 5)
YourlightincludesaremotecontrolPARC23 (6-FIG 1). It docks in the middle of the tripod
pole.
Therearetwobuttonsontheremote.Thetopone(A)istoturnthelightOnorOff.The
bottomone(B)istoselectthelightmodeamongHigh,Medium,Low,NightLightand
Flashing Alert Light.
Slide the remote up to take it off the holder. Always keep it in the holder when not in use.
The maximum control range is approximately 60 feet from the light.
Theremoteispoweredbya3VLithium-IonbuttonbatteryCR2032L. Remove the four
screws on the back cover to replace the battery.
The included remote control has been paired with your LED Work Light at the factory. If you are using a replacement
remote control, pairing the remote with the light is needed. Remove the battery pack from the light and reinstall it.
PressandholdtheOn/Offbutton(A)ontheremoteforatleast7secondsuntilthelightturnson.Thiscompletesthe
pairing process and the remote is ready to use.
NOTE: Yourlightwillturntoasleepmode24hoursafterbeingturnedofftosavebatterypower.Pressandholdthe
On/Offbutton(A)ontheremotecontrolfor2secondstoawakenthelight.
WARNING:Thisdevicecomplieswithpart 15ofthe FCCRules.Operationissubjecttothe
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
ADJUSTING THE LIGHT HEADS
Yourlighthasfouradjustablelightheads.Theycanbeconguredindozensofways
to get light where it is needed.
Flipping the Light Heads: Placethelockbutton(2)inUnlock position. Flip the
light heads on each side up or down to the desired position. Lock the light heads by
placing the lock button in Lock
position. See Fig 6 & 7.
Rotating the Light Heads: The light heads are able to rotate 330° around their
center axis. See Fig 8.
CAUTION: Do not force the light head. If it stops rotating in one direction, rotate
in the other direction to reach the desired position.
ACCESSORIES
Foot Spikes (FIG 9)
Three foot spikes are included for extra hold in tough conditions. Hammer the foot
spike into soft ground though two holes on the foot to give the light extra stability.
The foot spike can be stored in the feet as shown in FIG 9.
Shoulder Strap
An adjustable shoulder strap is Included for easy transport.