Use and Care Manual

FIG 2
A B
C D
BATTERY PACK
BATTERY PACK
HOLDER
LOCKING PIN
BATTERY
SYMBOL
FIG 3
FIG 4
BATTERY PACK
BATTERY POWER
INDICATOR
CHARGING
PORT
BATTERY
CHARGER
RUBBER
INSERT
5
English
ASSEMBLY INSTRUCTION
SETTING UP AND BREAKING DOWN THE LIGHT (FIG 2)
Yourworklightisfullyassembledandreadytouseoutofthebox.
To Set Up the Light: From folded position A to working position D.
1. Unwrap the storage strap (18).
2. Release the leg locking clip (10). See position A.
3. Expand the tripod legs (11) and then lock the leg locking clip. See
position B.
4.Placethelightheadlockingbutton(2)inunlockposition,thenip
the light heads (1) up. See position C.
5. Release the tripod locking clips (7), raise the tripod (8) and lock
the tripod locking clips. See position D.
6. Adjust the light heads (1) to a desired position.
To Break Down the Light: From postion D back to position A.
1. Release the tripod locking clips (7), lower tripod all the way down
and lock the tripod locking clips.
2. Fold the light heads (1) down in a tube shape.
3. Release the leg locking clip (10).
4. Raise the leg connector (9) until the light heads nest inside.
5. Lock the leg locking clip.
6. Wrap the legs with the storage strap.
Youmayalsorefertothe"QUICKSTARTGUIDE"sheetthatisincludedwiththeproduct.
INSTALLING AND REMOVING THE BATTERY PACK (FIG 3)
A12Vlithium-ionbatterypack(Model#PVLAB121)ispre-installedunderthetripodpole.
NOTE: Remove the insulation tape on the battery terminals before
using.
To Remove the Battery Pack from the Light: Slide down the
battery locking pin, and then remove the battery as shown in FIG 3.
To Install the Battery Pack: Facing the side of the tripod base
withthe"batterysymbol",slidethebatterypackintothebattery
holder all the way until it locks in place with a click, as shown in FIG
3. Lightly pull on the battery to ensure it is locked into place and will
not accidentally fall out.
OPERATION
CHARGING THE BATTERY PACK (FIG 4)
1.Plugthebatterychargerintoapowersource.
2. Unplug the rubber insert to expose the charging port.
3. Connect the battery charger to the charging port.
4. The battery power indicator will light and show the charging status:
 Redlightashing:Lowpowerandcharging.
 Yellowlightashing:Over50%powerandcharging.
 Greenlightashing:Over80%powerandcharging.
Solid green light: Fully charged.
You maycharge thebatterypackeitherinstalledorremovedfromthe
light. If charging while installed, the light works with maximum brightness
at 4000 lumens.