Use and Care Manual

FIG 3
B
A
FIG 2
A B
C D
4
English
ASSEMBLY INSTRUCTION
SETTING UP AND BREAKING DOWN THE LIGHT (FIG 2)
Your work light is fully assembled and ready to use out of box.
To Set Up the Light: FromfoldedpositionAtoworkingpositionD.
1.Unwrapthepowercord(13).
2.Releasetheleglockingclip(10).SeepositionA.
3.Expandthetripodlegs(11)andthenlocktheleglockingclip.See
position B.
4.Placethelightheadlockingbutton(2)inUnlockposition,thenip
thelightheads(1)up.SeepositionC.
5.Release tripod locking clips (7),raise thetripod (8) and lock the
tripodlockingclips.SeepositionD.
6.Adjustthelightheads(1)tobedesiredposition.
To Break Down the Light: FrompostionDbacktopositionA.
1.Releasethetripodlockingclips(7),lowertripodallthewaydown
and lock the tripod locking clips.
2.Foldthelightheads(1)downinatubeshape.
3.Releasetheleglockingclip(10).
4. Raise the leg connector (9) until the light heads nest inside.
5.Locktheleglockingclip.
6.Wrapthepowercord.
Youmayalsoreferto"QUICKSTARTGUIDE"sheetwhichcomeswiththeproduct.
OPERATION
ON-BOARD SWITCH
Yourlighthasaredon-boardswitch(5-FIG1).SeeFigure1foritslocation.ThisswitchturnsthelightOnandOffand
controls the light mode. The light mode rotates in the following sequence by each press on the switch:
Work Light - Night Light - Flashing Alert Light - OFF
Theswitchhasadelayed"OFF"function.Ifalightmodestaysonformorethan15seconds,thenextpressonthe
swich will turn off the light.
REMOTE CONTROL (FIG 3)
Your light includes a remote control PARC23(6-FIG1).Itdocksinthemiddleofthe
tripod pole.
There are two buttons on the remote control. The top one (A) is to turn the light On
orOff.Thebottomone(B)istoselectthelightmodeamongWorkLight,NightLight
andFlashingAlertLight.
Slide the remote control up to take it off the holder. Always keep it in the holder
when not in use.
Themaximumcontrolrangeisapproximately60feetfromthelight.
The remote control is powered by a 3V Lithium-Ion button battery CR2032L.
Remove the four screws on the back cover to replace the battery.
WARNING:This devicecomplieswithpart 15oftheFCCRules.Operation issubjecttothe
followingtwoconditions:(1)Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptany
interference received, including interference that may cause undesired operation.