Full Product Manual

BEST CUTTING AREA
FIG 12
DANGERIOUS
CUTTING AREA
DIRECTION OF
ROTATION
FIG 14
STATUS LIGHT
POWER ADAPTOR
BATTERY
CHARGER STAND
BATTERY POWER
INDICATOR
POWER INDICATOR
BUTTON
A
FIG 13
9
8
11
English
CUTTING TIPS (FIG 12)
•
Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
• The trimmer cuts when passing the unit from left to right.
This will avoid throwing debris at the operator.
• Avoid cutting in the dangerous area shown in FIG 12.
• Use the tip of the line to do the cutting; do not force string
head into uncut grass.
• Wire and picket fences cause extra line wear, even
breakage. Stone and brick walls, curbs, and wood may
wear line rapidly.
EDGING (FIG 13)
This trimmer can be easily changed to the edger mode.
1. Remove the battery pack
2. Press the edge shift button (9) and hold.
3. Rotate the bottom shaft (8) 180° clockwise.
4. Release the edge shift button.
WARNING: Never stand directly in the
path of the cutting line while edging. Always
stand to the left of the grass deflector to avoid
thrown debris, which could result in serious
personal injury.
CHARGING THE BATTERY (FIG 14)
NOTE:
Always Check that the power supply corresponds to the voltage on the ratings plate.
• Plug the power adaptor into a 120 Volt AC power source. The status light on the adaptor will illuminate green.
•Slide the battery all the way into the charger stand until it locks in place with a click, as shown in A-FIG 14. A red
status light indicates the battery is charging. The status light will turn to be green when the battery is fully charged.
• When the status light turns amber, it indicates the battery temperature is either too high or too low to be charged.
Wait the battery temperature back to room temperature before starting the charging.
• If the amber status light persists even when the battery temperature is in normal temperature range, the battery may
be damaged and will never be charged.
• Batteriesmaybecomewarmwhilecharging.Thisisnormal.
• Ifbatteryishotaftercontinuoususeinthetool,allowittocooldowntoroomtemperaturebeforecharging.Thiswill
extend the life of your batteries.
OPERATION