Instructions / Assembly

MAINTENANCE

Check the level of hydraulic fluid before each use. Replace the hydraulic fluid at the beginning of each

season or if the fluid level is low. Use an AW32 hydraulic fluid for operation over 40°F and automatic

transmission fluid for operation below 40°F.

Check the hydraulic fluid level

Warning: Lifting the log splitter is a two person operation. Once raised, make sure the log splitter is

stable before performing any maintenance.

1. Make sure the bleed screw (H) is closed.

2. Lift up on the handle of the log splitter. Make sure the splitter

is resting securely and will not fall.

3. Use the hex wrench to loosen the fluid drain bolt (I).

4. Pull out the bolt with attached dipstick.

5. Wipe the fluid off the dipstick.

6. Put the dipstick back in the fluid tank and then pull it out

again.

7. Check the fluid level. It should be between the two notches (J)

near the end of the dipstick.

8. Add fluid, if needed.

9. Replace the dipstick and tighten the fluid drain bolt.