INSTRUCTION MANUAL 196CC Plate Compactor Model # PS8810 Have product questions or need technical support? Please feel free to contact us! Website: www.Amerisuninc.com Toll free: 1-800-791-9458 M-F 9-5 EST Email: support@amerisuninc.
CONTENTS Technical data…...………………………………………………………... 3 General safety rules…….……………………………………………….... 4 Knowing your 196cc plate compactor.………….…. ….…….…………… 6 Assembly instruction…………………………………………….………. 7 Preparation……………………………………………………….………. 7 Operating instruction…………………………………………………....... 8 Maintenance……………………………………………………..……….. 11 Troubleshooting…………………………………………………………… 14 Plate Compactor exploded view………………………………………… 15 Plate Compactor parts list………………………………………………...
GENERAL SAFETY RULES • Before operating this plate compactor read and observe all warnings, cautions, and instructions both on the labels • • and in this owner’s manual. NOTE: The following safety information is not meant to cover all possible conditions and situations that may occur. This safety alert symbol is used to identify safety information about hazards that can result in personal injury.
SAFETY RULES • Do not operate near open flame. • Do not smoke near the plate compactor. • Always turn the plate compactor off before refueling. Allow it to cool for at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank. • • • • • • • • • • • • • • • • • • • Do not overfill fuel tank. Gasoline may expand during operation. Do not fill to the top of the tank. Allow for expansion. Always check for spilled fuel before operating.
Knowing your plate compactor 1. Throttle level 3. Frame 5. Engine supporter plate 7. Exciter 2. Handle 4. Belt cover 6. Bottom plate . 8.
Assembly instruction WARNING: This plate compactor is heavy. Some procedures may require lifting equipment or two people. HANDLE ASSEMBLY: • • • • The Plate Compactor is shipped with the lower handle already assembled and attached to the plate. To complete the handle assembly, loosen the knobs in the middle of the handle and swing the upper handle into place. Next, insert the bolt, washer and nut into the hole directly above the plastic knob. Tighten the nut and the plastic knob.
has reached the second thread from the lip of the opening. Check for oil leaks. Reinstall oil filler cap before starting engine. WARNING: This plate compactor may emit highly flammable and explosive gasoline vapors, which can cause severe burns or even death if ignited. A nearby open flame can lead to explosion even if not directly in contact with gasoline. STEP 2 - ADD GASOLINE: • Use fresh (within 30 days from purchase), lead-free gasoline with a minimum of 87 octane rating. Do not mix oil with gasoline.
WARNING: The exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. STARTING THE PLATE COMPACTOR: Check the oil and fuel levels. Turn the fuel valve to the “ON” position. Move the choke lever to the “START” position. Set the engine switch to the “ON” position. Move throttle lever to “MIN” position. Pull on the recoil starter handle slowly until a slight resistance is felt.
• • control the forward motion. Steer the machine by moving the handle sideways to the right or left． ALWAYS maintain good footing so that you do not slip and lose control when starting or operating the machine. Prior to operation • • • • • • • • • • • • 1. 2. 3. Make sure that all dirt, mud, etc.
Transportation Be sure to stop the engine while transporting. Close the fuel valve to avoid fuel leaking．In transportation by car, fix machine securely not to move nor to fall down．In case of driving for long distance or at off-road, drain the fuel out of fuel tank． Maintenance FILLING CRANKCASE WITH OIL: 1. Make sure the plate compactor is on a level surface. Tilting the plate compactor to assist in filling will cause oil to flow into engine areas and will cause damage. Keep plate compactor level! 2.
AIR CLEANER MAINTENANCE: Routine maintenance of the air cleaner helps maintains proper air flow to the carburetor. Check that the air cleaner is free of excessive dirt. 1. Remove air cleaner cover (a). Remove both elements and inspect them for holes or tears. Replace damaged elements. 2. Tap paper element (c) lightly to remove excess dirt. Replace paper element if it appears heavily soiled. 3. Wash foam element (b) in solution of mild detergent and warm water. Rinse thoroughly in clean water.
12. Store the emptied gasoline in a suitable place. CAUTION: Do not store fuel for more than 3 months. DRAINING THE FUEL TANK THROUGH THE CARBURETOR: 1. Turn fuel valve to “ON”. 2. Loosen drain screw from carburetor. Be sure to have a vessel prepared to catch the fuel that will flow out. 3. Ensure that all fuel has left the tank, fuel line, and carburetor. 4. Tighten the drain screw. 5. Turn the fuel valve to “OFF”.
TROUBLESHOOTING PROBLEM Engine will not start. CAUSE SOLUTION Engine switch is set to “OFF.” Set engine switch to “ON.” Fuel valve is turned to “OFF.” Turn the fuel valve to the “ON” position. Choke is open. Close the choke. Engine is out of fuel. Add gasoline. Engine is filled with contaminated or old gasoline. Spark plug is dirty. Change the gasoline in the gas tank and drain/ clean the carburetor. Clean spark plug. Spark plug is broken. Replace spark plug.
PLATE COMPACTOR EXPLODED VIEW 1 2． 15
PLATE COMPACTOR PARTS LIST Item Stock# Description Qty Item Stock# Description Qty 1 PS8810-001 Engine 1 24 PS8810-024 Spring Gasket 2 2 PS8810-002 Key 1 25 PS8810-025 Medium Flat Gasket 2 3 PS8810-003 Clutch Assembly 1 26 PS8810-026 Belt Cover 1 4 PS8810-004 Conical Flat Gasket 1 27 PS8810-027 Locked Nut 6 5 PS8810-005 Spring Gasket 1 28 PS8810-028 Shock Absorber 4 6 PS8810-006 External hexagon bolt 1 29 PS8810-029 Shock Absorber 4 7 PS8810-007 Exte
EXPLODED VIEW AND PARTS LIST (ENGINE) 17
ENGINE PARTS LIST Item Stock# Description Qty Item Stock# Description Qty 1 PS8810-E001 Bolt, M6×16 7 39 PS8810-E039 Gasket, Air Filter 1 2 PS8810-E002 Clip 1 40 PS8810-E040 Air Filter Lower Cover 1 3 PS8810-E003 Valve Cover 1 41 PS8810-E041 Air Filter Base Assembly 1 4 PS8810-E004 Breather Hose 1 42 PS8810-E042 Nut, M6 2 5 PS8810-E005 Gasket, Valve Cover 1 43 PS8810-E043 Clip 2 6 PS8810-E006 Rocker Arm Assembly 2 44 PS8810-E044 Cylinder Head 1 7 PS88
ENGINE PARTS LIST Item Stock# Description Governor Gear Bracket Qty Item Stock# Description Qty 1 96 PS8810-E096 Clip 1 77 PS8810-E077 78 PS8810-E078 Fuel Cap 1 97 PS8810-E097 Crankcase 1 79 PS8810-E079 Fuel Tank 1 98 PS8810-E098 Oil Seal, 25×41.
TWO (2) YEARS LIMITED WARRANTY Power Smart® is committed to building tools that are dependable for years. Our warranties are consistent with our commitment and dedication to quality. TWO (2) YEARS LIMITED WARRANTY OF POWER SMART PRODUCTS FOR HOME USE. Power Smart (“Seller") warrants to the original purchaser only, that all Power Smart consumer power tools will be free from defects in material or workmanship for a period of two (2) years from date of purchase.
