Instructions / Assembly

11
To fit the protector, insert the tails of the protector into the holes
located on the press plate of guard (see Fig. 4). The protector will
lift vertically when not in use.
WARNING: Never use the product without the guard proper fitted.
OPERATING INSTRUCTIONS
WARNING: Read and thoroughly understand all instructions and safety information before
operating this string trimmer. Failure to do so may cause serious injury or death. Do not allow
anyone to operate this string trimmer who has not read this manual. a string trimmer can be
dangerous if assembled or used improperly. Do not operate this string trimmer if you have doubts or
questions concerning safe operation. Call our customer service department at 1-800-791-9458 to address
these concerns.
STARTING/STOPPING THE STRING TRIMMER
Attach the outlet end of an extension cord to the plug on the rear of
the string trimmer.
NOTE: Use only approved outdoor extension cords.
Push the lock off button meanwhile squeeze the on/off switch to
switch the product on.
Release the on/off switch to switch the product off.
WARNING:
The tool runs for approximately 4 seconds after it has been switched off. Let the motor come
to a complete standstill before setting the tool down.
LINE FEEDING
1. Before starting ensure the cutting line is the correct length. Pull the cutting line to the edge of the
guard
Fig. 5
ON/OFF
SWITCH
Fig. 4
LOCK OFF
BUTTON