Instructions / Assembly

12
OPERATING INSTRUCTIONS
WARNING: Read and thoroughly understand all instructions and safety information before
operating this lopper saw. Failure to do so may cause serious injury or death. Do not allow
anyone to operate this lopper saw who has not read this manual. A lopper saw can be
dangerous if assembled or used improperly. Do not operate this lopper saw if you have doubts or
questions concerning safe operation. Call our customer service department at 1-800-791-9458 to address
these concerns.
ADDING BAR AND CHAIN LUBRICANT
Use premium bar and chain lubricant. It is designed for chains and chain oilers, and is formulated to
perform over a wide temperature range with no dilution required.
NOTE:
Lopper comes from the factory with no bar and chain oil added. Level should also be checked
after every 20 minutes of use and refilled as needed.
(See fig. 3)
1. Disconnect the lopper from the power supply.
2. Remove oil reservoir cap.
3. Carefully pour the bar and chain lubricant into the tank.
4. Wipe off excess lubricant.
5. Check and fill the oil tank when quick view oil
indicator is below the MIN indicator line.
6. Repeat as needed.
NOTE:
Do not use dirty, used, or otherwise
contaminated lubricants. Damage may occur to the bar or
chain.
NOTE:
It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank
after each use then run for one minute. When storing the unit for a long period of time(three months or
longer) be sure the chain is lightly lubricated; this will prevent rust on the chain and bar sprocket.
CONNECTING TO POWER SUPPLY
This product is designed with a cord retainer that prevents the extension cord from being pulled loose
while using.
NOTICE: Always use cord retainer to properly attach extension cord to lopper. Failure to use cord
retainer may result in damage to lopper and/or extension cord.
(See fig. 4)
1. From a loop with the end of the extension cord.
Fig. 3