Instructions / Assembly

11
WARNING:
Do not use this product if any parts on the packing list are already assembled to your product
when you unpack it. Parts on this list are not assembled to the product by the manufacturer
and require customer installation. Use of a product that may have been improperly assembled
could result in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories not recommended for use with
this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
INSTALLING THE FRONT HANDLE
Install the front handle so that the short side of the handle is
on the same side as the motor. See fig. 1-2.
1. Disconnect the lopper from the power supply.
2. Rotate the front handle knob counterclockwise to
Remove. Set knob and washer aside.
3. Remove the bolt cover and bolt.
4. With the jaws of the lopper closed, install the front
Handle in the vertical upright position.
5. Reinstall the bolt and bolt cover.
6. Reinstall the washer and front handle knob; rotate knob
clockwise to tighten securely.
WARNING:
Never position the front handle so that it is
forward of the vertical upright position.
Positioning the handle in this forward area could cause
the operator to lose control of the lopper and result in
serious personal injury.
Fig. 3
Fig. 1
Fig. 2