Use and Care Manual

CONNECTING AND REMOVING BATTERY

IMPORTANT!

The battery pack is not charged when it is purchased. Before using the power tool for the first time, place

the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the

instructions in the battery charger section.

To install the battery pack

To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in

the handle and push the battery into the handle. To connect the battery, slide the battery pack fully

forward. Until the latch locks into place.

To remove the battery pack

Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of

the tool .

WARNING:

Follow these instructions in order to avoid injury and to reduce the risk of electric shock or

fire:

• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.

• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on

any part of the power tool.

• Read, understand, and follow the instructions.

OPERATING INSTRUCTION

VARIABLE SPEED CONTROLLED TRIGGER SWITCH

Your tool is equipped with a variable speed trigger switch (see fig.1). The tool speed can be controlled

from the minimum to the maximum nameplate RPM by the pressure you apply to the trigger. Apply more

pressure to increase the speed and release pressure to decrease speed. This accurate speed control enables

you to drill without center punching. It also permits you to use as a power screwdriver. Bits are available

for driving screws as well as running bolts and nuts.

FORWARD/REVERSING LEVER & TRIGGER LOCK

WARNING: After tool use, lock trigger in “OFF” position to help prevent accidental starts

and accidental discharge.

Your tool is equipped with a forward/ reversing lever and trigger lock located above the trigger (fig. 1).

This lever was designed for changing rotation of the bit, and for locking the trigger in an “OFF” position.



For forward rotation, (with chuck pointed away from you) move the lever to the far left.



For reverse rotation move the lever to the far right.



To activate trigger lock move lever to the center off position.

CAUTION: Do not change direction of rotation until the tool comes to a complete stop.

Shifting during rotation of the chuck can cause damage to the tool.