Use and Care Manual

10
ASSEMBLY INSTRUCTION
WARNING:
Do not use this product if any parts on the packing list are already assembled to your product
when you unpack it. Parts on this list are not assembled to the product by the manufacturer
and require customer installation. Use of a product that may have been improperly
assembled could result in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories not recommended for use with
this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
INSERTING OR REMOVING THE BIT
WARNING: Always be sure that the tool is switched off and the battery cartridge is removed
before carrying out any work on the tool.

Move reverse switch lever to the center “OFF” position.

Remove battery pack and rotate the clutch ring to the drill bit symbol .

Rotate the chuck sleeve counter-clockwise viewing from chuck end, and
open chuck to approximate drill bit diameter (see fig.2).

Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go
for large bits.Close chuck by rotating the chuck sleeve clockwise and
securely tighten by hand.

To remove the bit, turn the sleeve counterclockwise.
WARNING: Do not use the power of the drill while grasping chuck to loosen or tighten bit.
Friction burn or hand injury is possible if attempting to grasp the spinning chuck.
INSTALLING AND REMOVING THE BELT HOOK
WARNING: Always be sure that the tool is switched off and the battery cartridge is
removed before carrying out any work on the tool.
Align the belt hook with the mounting hole of the base and tighten the screw. The belt hook can be
installed from the other side according to the operation habit.
Chuck sleeve
Fig.2