Use and Care Manual

12
OPERATION INSTRUCTION
VARIABLE SPEED CONTROLLED TRIGGER SWITCH
Your tool is equipped with a variable speed trigger switch (see fig.1). The tool speed can be controlled
from the minimum to the maximum nameplate RPM by the pressure you apply to the trigger. Apply more
pressure to increase the speed and release pressure to decrease speed. This accurate speed control enables
you to drill without center punching. It also permits you to use as a power screwdriver. Bits are available
for driving screws as well as running bolts and nuts.
FORWARD/REVERSING LEVER & TRIGGER LOCK
WARNING: After tool use, lock trigger in “OFF” position to help prevent accidental starts
and accidental discharge.
Your tool is equipped with a forward/ reversing lever and trigger lock located
above the trigger (fig. 1). This lever was designed for changing rotation of the
bit, and for locking the trigger in an “OFF” position.
For forward rotation, (with chuck pointed away from you) move the lever to the
far left. The indicator light will turn green (see fig.4).
For reverse rotation move the lever to the far right. The indicator light will
turn green.
To activate trigger lock move lever to the center off position.
CAUTION: Do not change direction of rotation until the tool comes to a complete stop.
Shifting during rotation of the chuck can cause damage to the tool.
ADJUSTABLE CLUTCH
Your tool features 21 clutch settings. Output torque will increase as the clutch ring, is rotated from 1 to 20.
The drill position will lock up the clutch to permit drilling and driving heavy duty work, and also
enables bits to be changed quickly and easily in the keyless chuck.
CAUTION: Before actual operation, drive a trial screw into your material or a piece of
duplicate material to determine which torque level is required for a particular application.
BRAKE
When the trigger switch is released it activates the brake to stop the chuck quickly. This is especially
useful in the repetitive driving and removal of screws.
Fig.4