Use and Care Manual

INSTALLING AND REMOVE THE AUXILIARY HANDLE

WARNING: Always be sure that the tool is switched off and the battery cartridge is

removed before carrying out any work on the tool.

 Insert the bolt into the hole above the variable speed trigger switch

(see fig.3).

 Tighten the auxiliary handle from the other side of the hole to the

bolt.

 The auxiliary handle can be installed from the other side according

to the operation habit.

INSTALLING AND REMOVE THE BELT HOOK

WARNING: Always be sure that the tool is switched off and the battery cartridge is

removed before carrying out any work on the tool.

Align the belt hook with the mounting hole of the base and tighten the screw. The belt hook can be

installed from the other side according to the operation habit.

CONNECTING AND REMOVING BATTERY

IMPORTANT!

The battery pack is not charged when it is shipped. Before using the power tool for the first time, place the

battery pack in the battery charger and charge.

To install the battery pack

To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in

the handle and push the battery into the handle. To connect the battery, slide the battery pack fully

forward. Until the latch locks into place.

To remove the battery pack

Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of

the tool .

WARNING:

Follow these instructions in order to avoid injury and to reduce the risk of electric shock or

fire:

• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.

• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on

any part of the power tool.

• Read, understand, and follow the instructions.

Auxiliary

handle

mounting hole

Fig.3