Use and Care Manual

10
ASSEMBLY INSTRUCTIONS
WARNING:
Do not use this product if any parts on the packing list are already assembled to your product
when you unpack it. Parts on this list are not assembled to the product by the manufacturer
and require customer installation. Use of a product that may have been improperly assembled
could result in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories not recommended for use with this
product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
INSERTING BITS
 Move reverse switch lever to the center “OFF” position.
 Remove battery pack and rotate the clutch ring to the drill bit symbol .
 Rotate the chuck sleeve counter-clockwise viewing from chuck end, and
open chuck to approximate drill bit diameter (see fig.2).
 Insert a clean bit up to the drill bit flutes for small bits, or as far as it will
go for large bits.
 Close chuck by rotating the chuck sleeve clockwise and securely tighten
by hand.
WARNING: Do not use the power of the drill while grasping chuck to loosen or tighten bit.
Friction burn or hand injury is possible if attempting to grasp the spinning chuck.
REMOVING CHUCK
 Rotate the clutch ring to the drill bit symbol .
 Open the chuck all the way, remove left-hand thread screw inside chuck by turning it clockwise.
 Insert the short arm of a 1/2" hex key wrench and close jaws on flats of wrench.
 Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from
spindle.
INSTALLING CHUCK
Always keep the spindle threads, the threads of the chuck and securing screw free of debris. To install a
chuck, reverse “removing chuck” procedure.
Chuck sleeve
Fig.2