Use and Care Manual

11
To remove the saw blade
1. Press the spindle lock button so that the blade cannot revolve.
2. Use the hex key to loosen the bolt counterclockwise.
3. Then remove the bolt, outer flange and saw blade.
CONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the power tool for the first time, place
the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the
instructions in the battery charger section.
To install the battery pack
To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in
the handle and push the battery into the handle. To connect the battery, slide the battery pack fully
forward. Until the latch locks into place.
To remove the battery pack
Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of
the tool .
WARNING:
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on
any part of the power tool.
• Read, understand, and follow the instructions.
OPERATING INSTRUCTION
STARTING/ STOPPING THE SAW
WARNNING: Before engage the switch trigger, check that the saw blade is properly fitted
and run smoothly, the blade clamp bolt is well tightened.
To start the saw
• Depress the lock-button (1)
• Depress the switch trigger (18).
Always let the blade reach full speed, then guide the saw
into the workpiece.
1
18
Fig.6