Instructions / Assembly

11
INSTALLING THE PROTECTOR
To fit the protector, insert the tails of the protector into the holes
located on each side of the motor housing (see fig 3). The
protector will lift vertically when not in use.
ATTACHING THE FRONT HANDLE
 Press the front handle onto the front tube, then align the
holes of clamp holder with the screw hole in the front
handle (see fig 4).
 Insert the two bolts, then tighten it securely
with hex wrench (see fig. 5).
INSTALLING THE FRONT TUBE AND LOWER TUBE
 Insert the front tube into the hole of lower tube, and then turn
the lock sleeve clockwise to lock the shaft in position (see fig
6).
Fig. 3
Fig. 4
Fig. 5
Fig. 6