Use and Care Manual

INSTALLING THE BLOWER TUBE

CAUTION: Always ensure that the tool is switched off and the battery is removed before making any

adjustments or maintenance procedures.

 Slide the small tube (C) over the big tube (B) until the latch on the big tube is inserted into the end

of the opening on the small tube and locks into position (see fig.1)

 Align the widest end of the big tube (B) with the front opening on the blower (A). (see fig 2)

CONNECTING AND REMOVING BATTERY

IMPORTANT!

The battery pack is not charged when it is purchased. Before using the blower for the first time, place the

battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the

instructions in the battery charger section.

To remove the battery pack

 Press the button (1) of battery door, then open it (see fig.3)

 Press the battery release button (2) at the back of the battery pack (see fig 4)

 Slide the battery pack backward, and then pull or lift the battery out of the tool (see fig 5).

To install the battery pack

To install the battery pack into the tool, align the rails of the battery pack with the rails in the tool and

push the battery into the housing. To connect the battery, slide the battery pack fully forward. Until the

latch locks into place.

WARNING:

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5