Instructions / Assembly

WARNING:

Follow these instructions in order to avoid injury and to reduce the risk of electric shock or

fire:

• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.

• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on

any part of the string trimmer.

• Read, understand, and follow the instructions.

STARTING THE CHAIN SAW

• Insert the battery pack.

• Make sure that there are no obstructions in contact with the guide

bar and the chain.

• Pull the brake baffle toward the battery pack and ensure that it

remains in the working position(see fig.1).

• Hold the front handle with you left hand, and hold the rear handle

with your right hand.

• Push forward the lock-off button and hold the trigger switch so

that the chain saw is started(see fig.2).

STOPPING THE CHAIN SAW

• Remove the chain saw from the cutting area, release the trigger switch and stop the chain saw.

• Push the brake baffle forward to switch it to the braking position.

WARNING:

The tool runs for approximately 4 seconds after it has been switched off. Let the motor come

to a complete standstill before setting the tool down.

PROPER GRIP ON HANDLES

• Wear non-slip gloves for maximum grip and protection.

• With the saw on a firm, fiat surface, hold the saw firmly

with both hands.

• Always grasp the front handle with the left hand and the

rear handle with the right handle.

• The fingers should encircle the handle, with the thumb

wrapped under the front handle (see fig.3).

Fig.1

Fig.2

Fig.3