Instructions / Assembly

10
WARNING - Never use waste or reclaimed oil. This results in damage to the oil pump, saw
chain and guide bar.
Filling oil tank
1. Set chain saw on any suitable surface with Oil Tank Cap facing upward.
2. Clean area around the Oil Tank Cap with cloth and unscrew the cap by turning it counter clockwise.
3. Add chain oil until reservoir is full.
4. Avoid dirt or debris entering oil tank, refit Oil Tank Cap and tighten by turning clockwise until hand
tight.
OPERATION
Adjusting pole length
The pole saw has a telescoping pole assembly that will extend from 71 inches (fully retracted) to 94.5
inches (fully extended).
An adjusting knob near handle is used to hold the pole in
position at any extended length.
1. To extend the pole, loosen the adjusting knob. Pole
will slide freely.
2. Pull inner tube out to desired length of extension.
Note: only extend pole to minimum length required to reach limb
that is being cut.
3. To lock pole in position, tighten adjusting knob.
Turn on the pole saw
1. Use both hands to grip Pole Saw. Use only designated grip areas when operating Pole Saw. Use firm
grip. Thumbs and fingers must wrap around Pole Saw handle and pole.
2. Make sure your footing is firm. Keep feet apart. Divide your weight evenly on both feet.
3. When ready to make a cut, press in trigger switch lock-out and squeeze trigger switch. This will turn
pole saw on.
Warning - Never stand directly under the limb you are trimming. Always position yourself
out of the path of falling debris.
Warning - Never stand on a ladder or other type of unstable support while using the pole saw.
Warning - Do not use pole saw near cable, electric power or telephone lines. Maintain a
minimum clearance of 10 feet from all power lines.
Warning - Keep other persons from cutting end of pole saw an d at a safe distance from work
area.
Adjusting Knob