Use and Care Manual

19
TRANSPORT&STORAGE
TRANSPORT, HANDLING
WARNING: Please empty the fuel tank before transporting, to avoiding the engine leaked. For
avoiding the cutting attachment damaged the brush cutter and people, please removed the
cutting attachment ,and at the same time, resile the brush cutter as factory state , and then
casting all parts into the package. Before transporting, all parts should be packed and validated safe.

The engine should be turned off when the unit is moved
between work areas.

After the engine has stopped ,the muffler is still hot. Never
touch hot parts such as the muffler.

Confirm that the fuel has not leaked from the tank.

Allow the engine to cool, empty the fuel tank and secure
the unit from moving before transporting in a vehicle, if the
blade is fitted , always use the blade guard.

Installing blade guard (See fig.24).

Open the blade guard and install on the blade ,then put the
pin into the guard notch.
WARNING:
Always place the blade guard on the blade when the unit is not in use.Remove the
blade guard before using the unit. If not removed,the blade guard could become a thrown object
as the blade begins to turn.
EXTENDED STORAGE
WARNING:
Do not store in a closed area where fuel vapors can reach an open flame from hot
water heaters, heaters, furnaces, etc. Store in a locked, well ventilated area only.

Inspect, clean and repair unit if necessary.

Remove all fuel from tank.

Start engine-This will consume all fuel in fuel line and carburetor.

Remove spark plug and pour one tea spoon of clean motor oil into spark plug hole of cylinder-replace
spark plug.

Store in clean, dry, dust free area.
Fig.24