Use and Care Manual

USING THE SHOULDER HARNESS

WARNING: Proper shoulder strap and handlebar adjustments must be made with the engine

completely stopped before using unit.

1. Assemble and adjust the shoulder harness and belt (See fig.8).

2. Adjust the shoulder-harness button,and move the hook to your waist, then adjust the belt (If there

is a belt).

3. Hang the latch tab on the harness hook.

4. If the brush cutter doesn't balance,then adjust the harness hanger,and the handlebar,until the it balances.

5. To quickly detach the brush cutter from the harness, pull the quick-release latch tab upward.

6. Insert the latch tongue in the slot of the quick-release latch to reattach the brush cutter to the harness.

WARNING:

Before using, please check the shoulder harness and confirm it is OK. Encounter

danger,please stop the brush cutter immediately,and pull the quick-release latch tab,the brush

cutter will be depart from your body.

FUEL&OIL MIXTURE

WARNING: • Never fill the fuel tank to the very top (under 3/4 of the tank).

• Never add fuel to the tank in a closed non-ventilated area.

• Do not add fuel to this unit close to an open fire or sparks.

• Be sure to wipe off spilled fuel before attempting to start engine.

• Do not attempt to refuel a hot engine.

Fuel used for this model is a mixture of unleaded gasoline and approved engine lubricant. When mixing

gasoline with two-cycle engine oil, use only gasoline which contains NO ETHANOL or

METHANOL(Types of Alcohol) . Use fresh (within 30 days from purchase) 87 octane or higher unleaded

gasoline known to be of good quality. This will help to avoid possible damage to engine fuel lines and

other engine parts.

Fig.8