Use and Care Manual

BLADE INSTALLATION

WARNING: Wear protective gloves when handling or performing maintenance on the blade

to avoid injury. The blade is sharp and can cut you even when it is not moving.

WARNING: Do not attempt to use any blades, washers, nuts, or fastening hardware other than

shown in the following illustrations. These parts must be provided by the manufacturer and

installed as shown below. Failure to use proper parts can cause the blade to fly off and seriously

hurt you or others.

1. Insert the hex key (2) into the specific hole in the angle

transmission (3) and rotate the blade (1) by hand until the

hex key enters the inner hole, blocking rotation (See

fig.5).

2. Remove the split pin (4) and unscrew the nut (5) in a

clockwise direction.

3. Pull out the washer (6) and the outer ring-nut (7) and remove

blade.

4. Ensure that the grooves in the inner ring-nut (8) mach up

perfectly with the angle transmission (3).

5. Fit the blade (1) and outer ring-nut (7).

6. Refit the washer (6) and the nut (5), fully tightening it in an

anticlockwise direction.

7. Reposition the split pin (4) and refold the two ends.

8. Remove the hex key (2).

HEADLINE INSTALLATION/REPLACEMENT

1. Insert the hex key (2) into the specific hole in the angle transmission (3) and rotate the cutting line

head (1) by hand until the hex key enters the inner hole, blocking rotation (See fig.6).

2. Ensure that the grooves in the inner ring-nut (4) mach up perfectly with the angle transmission(3).

3. Fit the cutting line head (1) screwing it up in an anticlockwise direction.

4. Remove the hex key (2).

Fig.5

Headline replacement

Fig.6

Fig.7