Use and Care Manual

10
Fig.3
ASSEMBLY INSTRUCTION
The following section describes steps necessary to prepare the brush cutter for initial use. If after
reading this section, you are unsure about how to perform any of the steps please call [phone]
Mon-Fri 9-5 EST for customer service. Failure to perform these steps properly can damage the brush
cutter or shorten its lifespan.
INSTALLING BRUSH CUTTER ATTCHEMENT
CAUTION: When installing brush cutter attachment, place the
unit on a flat surface for stability.
Pull out the stop pin (2) and push the lower part of the rod (1) right
down until the stop pin (2) slots into the hole (3) in the rod. This is
easier to do if you rotate the bottom of the rod (4) slightly in both
directions. The pin (2) is in place when it is completely lodged in the
hole. Lastly, tighten the knob (4) securely (See fig.2).
INSTALLING HANDLE
Position handle in a comfortable operating position and tighten four M5
×
25 screws.
WARNING:
Do not attempt to disassemble the two special
screws. The two clamps position has been adjusted at a suitable
place,do
not attempt to remove or move them. Otherwise, it can
result in serious personal injury.
INSTALLING PLASTIC BLADE SHIELD
CAUTION:
The blade shield must be properly installed. This shield
helps provide partial protection to the operator, and others from the
risk of thrown objects and other debris.
1. Install the safety cover on the shaft with the safety cover bracket and the
screws provided (See fig.4).
2. Tighten the screws after setting the safety cover bracket at the
appropriate position.
Fig.2
Fig.4