Full Product Manual

9
Step 1 – SETUP WHEEL KIT
ATTACH THE HANDLE
The handle attaches to the generator frame on the same side as the recoil starter (left side when facing
control panel). To attach the handle to the generator frame, perform the following steps:
1. Take left handle bracket (6) and line up the hole in the handle
bracket with the hole on the generator frame.
2. Secure the bolt M8x28 (7).
3. Take right handle bracket (8) and line up the holes in the
handle bracket with the holes on the right side of generator
frame.
4. Secure the bolt M8x28 (7).
5. Take handle and line up the holes in the handle with the holes
on the left and right handle bracket.
6. Secure the bolts M8x38 (9) with the nuts M8 (12) on both side
of handle bracket.
ATTACH FRONT FOOT
1. Put the recoil starter side of generator on the ground.
2. Setup front foot with 2 screws (4) and 2 nuts (12) as attached
picture.
ATTACH WHEELS
1. Slide the wheel axle (1) on the frame as attached picture.
2. Slide the wheel (3) onto the axle and secure in place using a cotter
pin (10).
3. Repeat steps 2 for the other side.
Left handle bracket
Right handle bracket
Wheel axle
Cotter pin